
Kunak air Pro

The air quality monitoring station
GRECiOT in collaboration with Kunak presents the Kunak air PRO air quality measuring station.
After 8 years of research, development and pilot installations, the most accurate Air Quality Measurement Station was created.
Easy installation and change of consumables, remote sensor calibration and the simplest, secure Cloud real-time data management system.


Features

Easy & Fast installation
Set up in less than 10 minutes with
visual diagnosis in a built-in display.

Cartridges system
Replace and combine pollutant
sensors with a plug & play system.

Proven accuracy
Proven as the best-in-class system
by independent organizations.

Easy calibration
Adjust the baseline and span
remotely.

Add environmental sensors
Connect wind, rain, noise, and
other sensors.

Air quality platform
Visualize, analyse and manage
your data in the cloud.

Fully autonomous
Autonomous operation with its
built-in battery and solar panel.

Real-time data
Access to your data and alarms
in real-time.

Multi pollutant
Measure up to 5 gases and
particulate matter at once.

Specifications
Dimensions | 257 x 270 x 225 mm |
Weight | <3.5 kg |
Enclosure | PMMA & Polycarbonate & Stainless steel |
Operating temp | -20 ºC to 60 ºC |
Operating RH | 0 to 99 %RH |
IP rating | IP65 |
Battery | Lithium 2.9Ah or 26Ah |
External supply | 7 – 12 Vdc. Charger or Solar panel |
Autonomy | 24/7 with solar panel or charger |
Power consumption | 0.08-1.2W (depending on configuration) |
Communications |
Multi-Band 2G/3G/4G (LTE-FDD/LTE-TDD/UMTS/HS- DPA/HSUPA/HSPA+/GSM/GPRS/EDGE) or Ethernet |
GNSS | GPS, GLONASS, GALILEO and BEIDOU |
Gas sensors | CO, CO2, NO, NO2, O3, SO2, H2S, NH3 & VOCs |
PM sensor | PM1, PM2.5 & PM10 |
Internal status | Temp./Battery/Charging voltage & current/Signal |
Built-in sensors | Temp./Humidity/Atmospheric pressure/Dew point |
| #3: Noise meter & Digital output (Relay) |
Sampling freq. | 3Hz gases, 1Hz particles |
Avg. periods | From 10 seconds to a maximum of 24 hours |
Sending periods | From 5 minutes to a maximum of 24 hours |
Remote management | Bidirectional communications Remote configuration and calibration |
SIM | Embedded eSIM and SIM holder |
Additional #4: Modbus RS485 RTU & 4-20mA & Configurable
Probes & power supply output
Actuators #5: Anemometer & Rain gauge inputs